Installation and debugging of Hesper rubber hose crimping machine

2023-10-13 06:11:41

We (Shandong Hesper) except provide various of rubber hoses, also provide rubber hose crimping machine, rubber hose skiving machine and rubber hose cutting machine, can customize machines according to your local electricity and your capacity requests.

During the installation and debugging of hose crimping machine, there are many details that need to be paid attention to. The main things to pay attention to in hose crimping machine include transportation, installation, micrometer, pressure adjustment, oil filling, power connection, and mold opening speed adjustment.

1. Transportation: Hesper rubber hose crimping machine is suitable to be transported by a forklift, and the bottom of hose crimping machine is stressed. It is strictly prohibited to turn the hose crimping machine upside down, and is strictly prohibited to lift the machine head, motor, and electrical box parts.

2. Installation: Hesper hose crimping machine needs to be placed horizontally on a stable foundation and grounded.

3. Micrometer: Used to adjust the shrinkage of the crimped hose. A half-circle counterclockwise presses in 1mm more, and a half-circle clockwise presses in 1mm less.

4. Pressure adjustment: According to the maximum pressure of hose crimping machine system, pressure adjusted by the relief valve. Adjust it clockwise to increase the pressure, and adjust it counterclockwise to decrease the pressure (it has been adjusted in our factory, and you can adjust it yourself if necessary).

5. Oil filling: Open the fuel tank cover and add 68# anti-wear hydraulic oil to the 2/3 position of the oil level gauge.

6. Connect the power: Connect the power cord to the specified power supply of hose crimping machine, start the motor and observe the steering. The motor steering should be consistent with the direction marked on the motor. If the motor rotation is inconsistent with the marked direction, please swap the positions of the two power cords.

7. Mold opening speed adjustment: The mold opening speed is controlled by the diverter valve. Adjust clockwise to increase the opening speed, adjust counterclockwise to slow down the opening speed. However, if the opening speed is too fast, the noise will increase. , the optimal value is no more than 10Mpa (it has been adjusted before leaving the factory, you can adjust it yourself if necessary).

The installation and debugging of the hose crimping machine cannot be ignored. Any queries in installation and debugging, contact us freely.

Shandong Hesper Rubber Plastic Co., Ltd. also supply various of rubber hoses, polyurethane products, hydro cyclone, and so on. Welcome to Contact Us, or find more details in our Website.